Bedside lamp

This is a bedside lamp, of approximately 28 cm high and 23 cm diameter
I have produced it during my recent Fusion 360 training
For french people, this (very good) training is proposed by Sylvan La Rochelle
It is very well made, and headed by interesting and competent peoples
All that said, back to the lamp

The lamp is made of four parts:
+ Lampshade
Making the scarf invisible is a challenge
Cura scarf seam feature did not work well in my case, so my best setting consisted in:
- printing outside to Inside without optimisation, 0.1 layers
- Z seam user specified, Z relative checked, X=0, Y=20
- Combing: not in skin
- Infill: 100%
- Tree support at 65°
+ Lampbase
May be printed in two colors with a filament change
(if using 0.2 layers, change is before layer 28)
Tree support (75°)
+ Lampstand (upper and lower)
0.1 layer (but 0.2 may also work)
no support, but brim recommended for upper part

Hardware used:
(see Hardware directory for pictures)
+ G4 LED Bulb 3W 12V