Thingiverse
BedSide Tray
por Taeho98
18
Descargas
17
Likes
0
Makes
I initially designed this for my grandma, but I might as well share it here.
The purpose of this tray is to be latched to the side of a bed and to hold items.
The hook is made for 24mm thick material and it takes DIN912 M3 bolt and DIN934 M3 nuts.
- The entire print took me about 9.5 hours and about 300grams of filament. This is printable without support but I did use a brim.
- The tray is printed in two parts and glued together with super glue.
- There are 2 rods used for alignment of the 2 parts during assembly; 5mm and 3mm.
- Dimensions of the parts and bolt locations are given in the drawing so you can replace the hook with your very own part to suit your needs.
The purpose of this tray is to be latched to the side of a bed and to hold items.
The hook is made for 24mm thick material and it takes DIN912 M3 bolt and DIN934 M3 nuts.
- The entire print took me about 9.5 hours and about 300grams of filament. This is printable without support but I did use a brim.
- The tray is printed in two parts and glued together with super glue.
- There are 2 rods used for alignment of the 2 parts during assembly; 5mm and 3mm.
- Dimensions of the parts and bolt locations are given in the drawing so you can replace the hook with your very own part to suit your needs.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
