Thingiverse
Animals
Zum Modell
Beeline
15
Downloads
15
Likes
0
Makes
For GISH 2021, the Beeline mascot!
Printed in PLA with support at about 6 cm long. you may want to go a little bit bigger or find another way to strengthen the legs, I used a 3d pen with some scrap filament to thicken them and attach the wings. The antennae are bits of wire, heated with a lighter and pushed into the head.
Printed in PLA with support at about 6 cm long. you may want to go a little bit bigger or find another way to strengthen the legs, I used a 3d pen with some scrap filament to thicken them and attach the wings. The antennae are bits of wire, heated with a lighter and pushed into the head.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
