Beginners Quad

I found this design scurrying around down at the bottom of my hard drive. If I remember right this was a design that I did up right quick to satisfy the pre-rec so I could take the classes to get my drafting certification. This quad was designed to press-fit mount 380 size STANDARD car motors and hold a 1300mah 3 cell LiPoly pack. Although the motor pods do fit on the ends of the arms quite snugly a dab of glue wouldn't hurt ta just keep em on there good an tight. You'll also need 8 small bolts (sorry, don't remember the size of these) and you'll also need a couple of bolts with wingnuts or thumbscrews for the battery strap. Assembly requires that the arms go in-between the chassis plates. *NOTE* The motor pods have a hole at the bottom for motor wires to lead through but this may be too small for some wire packs but I'll fix this as soon as I get the chance after break.