Begode Blitz - Mudguard Extender

2024-12-31: Updated the design, the extender now has a flat top so you can print it upside down without any supports but you have to print it slowly.

A mudguard extender for the Begode Blitz.

Due to it's design the mudguard on the Blitz doesn't stop water and dirt from spray up and around, this is an extender that helps with that.

Printing Settings:

Print in flexible material, preferably a little bit stiffer TPU like TPU95A, since you are printing with flexible material and due to the tall thin walls print very slowly, lower all the acceleration settings, you don't want the flexible material to jiggle around while printing it needs to be slow and steady, my print took 10 hours.

I print with a 0.6 mm nozzle and will provide wall thickness in millimeters for easy conversion to other nozzle sizes.

You don't need supports for this print.

Walls: 2 (0.5mm x 2 = 1mm)
Top/Bottom Layers: 2 (0.3mm x 2 = 0.6mm)
Infill: 10% Gyroid

Installation:

Install with double sided tape as pictured i