Thingiverse
Begode MTEN4 caps
von tritbool
5
Downloads
6
Likes
0
Makes
Caps for the Begode MTEN4 EUC.
The button-side one is designed to stay in place. The pin in the middle makes it possible to press on the cap to use the power switch with the cap in place.
The charging port-side one does not have a pin in the middle.
I advise to print them with TPU that is below 90A tough. I designed two thinner versions that can be printed with TPU 90 + but it is less usable and harder to install.
The button-side one is designed to stay in place. The pin in the middle makes it possible to press on the cap to use the power switch with the cap in place.
The charging port-side one does not have a pin in the middle.
I advise to print them with TPU that is below 90A tough. I designed two thinner versions that can be printed with TPU 90 + but it is less usable and harder to install.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
