Belt Pouch - Pull Case

Pouch - Fits with other pouch in my designs.
The main body slides in and out of the case attached to the belt.

Please ignore the splatters of paint on the prototype, it’s from another project.

I printed this in PLA+, but I can't see why any material wouldn't work just as well.
There are 4 wall's and 10% infill and I printed at a 2mm layer height.
I printed the case upright and the insert horizontal.
I used supports but that’s down to your discretion.

There are two versions of the outer case.
One with a Molle attachment that's designed for standard belts like the one pictured. (Note, I made this to fit through all three loops on this style of belt)
One has a belt loop for a normal belt, you may need to alter to fit your belt.

There are two versions of the inner slide.
One is just an open space 20mm deep / 20mm wide / 130mm height
The other has a divide, because why not.

The pictured pouches are my prototypes so please ignore the issues you'll see. I’ve made s