Benchie (Benchy)

Thought it would be funny to make an actual bench for a benchmark test lol.This model tests:1. Tolerances There are 4 circles that should release if the tolerances are good. Tolerances are in mm.2. Sharp corner overextrusionRun your fingernails across the corners, they shouldn't protrude. Each corner is filleted in 0.1mm incrementsThis is an example of an overextruded corner3. 45 degree overhangsThe Benchie's legs are tilted at 45 degrees for this test.4. BridgingPrinting one side without supports allows for a bridging test Checking the underside of the bridging test will show bridging capabilities.5. Support interfaceCheck the underside of the supported bar to ensure a clean surface.6. Stringing