Thingiverse
Bibo 2 Bed Levelling
von seagull08
28
Downloads
15
Likes
0
Makes
I'm no 3D printer expert and this is not official Bibo. It's just something I made to help me with my bed levelling demons. Maybe it will be of help to others.
Using just the piece of paper method, I have not always been very successful in levelling the bed. So I have copied the pattern of a Creality Ender 3 bed levelling design I found here and made it fit to the Bibo's dimensions.
It's a little smaller than the maximum stated print bed size at 205mm by 175mm, as I don't like to extend to the very edges when doing a print.
I have found this to be very useful in getting a nice level bed - I make small adjustments while printing it to get the best result I can.
It will print 1.5mm high but obviously you can abort the print before that to retry after your adjustments or once you are happy that it's all set up right.
Using just the piece of paper method, I have not always been very successful in levelling the bed. So I have copied the pattern of a Creality Ender 3 bed levelling design I found here and made it fit to the Bibo's dimensions.
It's a little smaller than the maximum stated print bed size at 205mm by 175mm, as I don't like to extend to the very edges when doing a print.
I have found this to be very useful in getting a nice level bed - I make small adjustments while printing it to get the best result I can.
It will print 1.5mm high but obviously you can abort the print before that to retry after your adjustments or once you are happy that it's all set up right.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
