MakerWorld
Other House Models
Ver Modelo
BicPick Lighter Case
67
Descargas
40
Likes
45
Makes
BicPick Lighter Case 🔥 Instructions:Print will pause at layer 56Remove the pick part and clean the brim offInsert into opening at the back of the lighter case (it will be tight!)Resume printRemove remaining brim when print is finished Move the pick up and down a few times to “break in” Tips:Print pick at 0.1mm layer height and case at 0.2 layer heightPrint with 3 walls minimumBe careful not to unstick the print while inserting pick during pauseKeep pause time to a minimum for a better finish NOT FOR COMMERCIAL USE For commercial use license, visit:https://buymeacoffee.com/we3d Supporters get FREE files and Commercial Use License! 📈
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
