Thingiverse
Bicycle Fender Clip
door SsteveSstrong
144
Downloads
67
Likes
1
Makes
I recently added fenders to my commuter/hybrid bike to keep some of the mud off of my butt and bike. The fenders came with exactly one clip, and it did a DECENT job of holding the fender in place, but towards the back of the rear tire, the fender was flopping around a bit more than I liked, so I decided to design/print up some additional clips.
The first design was a straight replacement for the factory clip. In the off chance I busted the original. The second design stripped out the tall vertical mounting point, and just has the two side loops. That's ultimately what I wanted, since the plan was to zip-tie the clip centered over the rear wheel.
Oh, this is also dependent upon you having some sort of bike rack installed, with a vertical-ish post that you can tie up to...
The models are for a 45mm fender, but you could easily scale it to match whatever you're working with.
The design was made in Autodesk 123D, by carefully measuring every aspect of the factory clip, and
The first design was a straight replacement for the factory clip. In the off chance I busted the original. The second design stripped out the tall vertical mounting point, and just has the two side loops. That's ultimately what I wanted, since the plan was to zip-tie the clip centered over the rear wheel.
Oh, this is also dependent upon you having some sort of bike rack installed, with a vertical-ish post that you can tie up to...
The models are for a 45mm fender, but you could easily scale it to match whatever you're working with.
The design was made in Autodesk 123D, by carefully measuring every aspect of the factory clip, and
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
