BigTape

This is a big tape dispenser...

The uploaded files differ a bit from the photo of the real object because i wasn't paying enough attention when designing.
In my version there is a bit of space between the knife holder and the pole that the tape should run over. . .that meant i had to glue the knife holder to the pole.

In the uploaded files this is all corrected, also there is a bit more space to grab the tape.

Tape size i used : width : 50mm
hole : bigger than 75 mm


What you need is the following :

Filament
patience (it took me like 8 hr to print)
A strip of sheet metal you can use to make the tape knife..
I used 2 screws to attach the metal knife to the plastic. . .

good luck..