MakerWorld

Organizers

Biltema Pegboard / Toolboard Hooks

von ggalaxyy · Organizers

58 Downloads

16 Likes

29 Makes

Hooks / holders for Biltemas Pegboard system but should work just fine with most similar pegboard systems I guess. Fastens with a single or two screws. I actually only use one screw with my system as It's plenty enough for it to hold on without problem. Comes in three different sizes. 2CM, 4CM or 6CM lenght. Fits any Pegboard system with 1,2mm (³/₆₄ Inches) spacing between holes. I print these in PLA with 15% infill. If you're planing on hanging very heavy items on these I recomend a higher infill or material all together.

Biltema hanger Holder hook hooks krok krokar organizer pegboard pegboard hanger pegboard hook pegboard system tavla tool holder tool storage toolboard toolbox workshop tool

Kategorie

Organizers

Quelle

MakerWorld

Veröffentlicht

27.10.2025

Aktualisiert

30.04.2026

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat

STL

Material

PLA

Nachbearbeitung

Hardware

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Biltema Pegboard / Toolboard Hooks

Ähnliche Modelle

Zur Sammlung hinzufügen