Thingiverse
Binary Blaster Case
door Heiden92
0
Downloads
1
Likes
0
Makes
I just purchased a Binary Blaster from Sparkfun, but hated how there was no case so it was challenging to hold.
This is a case that creates a more enjoyable hold than the typical Binary Blaster would provide. I wanted it to be simple and how the Binary Blaster is laid out it wouldn't look good to cover the front.
To install, put on the spacers as these will be what provides the friction fit for the device. It should not require any post-processing. Simple.
This is a case that creates a more enjoyable hold than the typical Binary Blaster would provide. I wanted it to be simple and how the Binary Blaster is laid out it wouldn't look good to cover the front.
To install, put on the spacers as these will be what provides the friction fit for the device. It should not require any post-processing. Simple.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
