Thingiverse
Bird fountain
by samarray
6
Downloads
8
Likes
0
Makes
6 parts, top for bird bath and bottom for stand and sump, a lit plate and spout, then two alignment rings to be superglued on
the spout has holes to be screwed/bolted/pined to the lid. it's a channel for a small hose to be set within and zip tied if necessary.
YOU STILL NEED PUMP, POWER, HOSE. i used a small 5v pump and aquarium hose.
the alignment rings are glued in in order to NOT NEED SUPPORTS
water holding parts need to be highest quality prints the base and the top.
to print watertight i used like 5 walls and 6 top and 4 bottoms. turn up nozzle heat as well. print top and bottom at best quality everything else is fare game
the spout has holes to be screwed/bolted/pined to the lid. it's a channel for a small hose to be set within and zip tied if necessary.
YOU STILL NEED PUMP, POWER, HOSE. i used a small 5v pump and aquarium hose.
the alignment rings are glued in in order to NOT NEED SUPPORTS
water holding parts need to be highest quality prints the base and the top.
to print watertight i used like 5 walls and 6 top and 4 bottoms. turn up nozzle heat as well. print top and bottom at best quality everything else is fare game
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
