Bison

Picture source/author: @hanzo.ai.art / HanzoAI Then used HueForge v0.8.1 to create the model.   Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.   Model is 150x200 mm in size. Do not adjust the height (Z) in your slicer! The layers would not be correct. You can only modify the X and Y dimensions. You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 2.1mm and the Actual Depth is 2.1mm   It is possible to print without AMS by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.   These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use. Filaments Used: PLA Elegoo+ Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA Elegoo + Gray Transmission Distance: 3 PLA Elegoo Matt White Transmission Distance: 6 This print uses 4 unique filaments Swap Instructions: Start with Black At layer #10 (0.88mm) swap to Blue Gray At layer #13 (1.12mm) swap to Gray At layer #17 (1.44mm) swap to White for the rest.