Thingiverse
Bit Driver
von Morborg
5
Downloads
4
Likes
0
Makes
This is the same concept as the small bit driver for 1/4" standard bits, but redesigned for a 5.9mm x 12.5mm neodymium magnet.
The intention is also to print upside-down from the original for a slightly better finish. I removed the small fillets that make for a rough edge.
An M601 pause command is required at 22.25mm to insert the magnet, it's placed to close to the back of the bit for maximum effect.
The intention is also to print upside-down from the original for a slightly better finish. I removed the small fillets that make for a rough edge.
An M601 pause command is required at 22.25mm to insert the magnet, it's placed to close to the back of the bit for maximum effect.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
