Thingiverse
Bitaxe Argon THRML 60 Socket (Enhanced Threaded Inserts Version)
von etkaar
5
Downloads
13
Likes
0
Makes
Enhanced version with threaded inserts (M3x5.7 mm). Use the washers for the back side to protect the PCB. The threaded inserts are melt down from the other side, so that the metal will not touch the PCB. The screws will still screw in, since the direction makes no difference.
Printed PETG V0 by Prusament which is a fire retarded filament. If you don't own these, do on your own risk. Don't use PLA, as this is easily flamable.
The Argon THRML 60-RC is not compatible with the fan connector on the BitAxe Gamma, so you need to rewire fan connector as follows:
- Yellow => Blue
- Black => Yellow
- Blue => Red
- Red => Black
You can easily pull out the wires by lifting the connector barbs with a needle or scalpell, so you don't need to cut the wires and crimp them.
Printed PETG V0 by Prusament which is a fire retarded filament. If you don't own these, do on your own risk. Don't use PLA, as this is easily flamable.
The Argon THRML 60-RC is not compatible with the fan connector on the BitAxe Gamma, so you need to rewire fan connector as follows:
- Yellow => Blue
- Black => Yellow
- Blue => Red
- Red => Black
You can easily pull out the wires by lifting the connector barbs with a needle or scalpell, so you don't need to cut the wires and crimp them.
etkaar veröffentlicht auch auf
30 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
