Bloom

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.3mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Silver Transmission Distance: 0.5 PLA BambuLab Basic Jade White Transmission Distance: 5 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Orange Transmission Distance: 5This print uses 6 unique filaments. Substitute as needed. Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Blue Gray At layer #12 (1.04mm) swap to Silver At layer #13 (1.12mm) swap to Jade White At layer #17 (1.44mm) swap to Black At layer #19 (1.6mm) swap to Red At layer #21 (1.76mm) swap to Orange At layer #23 (1.92mm) swap to Jade White for the rest.