Blorp Dragon

EDIT: I was having to scale up the print because It kept coming up in Cura super small, but ERICKDR 3D Designs did me a huge favor and fixed the files, saying that the files are originally reading as inches and the slicers are converting them to MM... so these should work much better now, and you can still scale them up however. (The files ending in FIXED)

So after test printing a small army of Blorps here are some notes about what worked well for me..

If you're printing the one with the collar, my best print was around 5.5 inches (Could also be larger) so that his collar tag moves a little.
(Scale for this was 360.56%)

I had to rotate him about 3 degrees forward to get all 4 feet touching the build plate.

Support note- I was getting issues with rough areas above the supports and had to lower the line height and temp a little bit to get more successful prints here. With a .4mm nozzle I was using .16mm line height. Temp depends on your filament.

I use Cura, So I used: