Thingiverse
BLTouch Adapter
von 6squarefeet
118
Downloads
77
Likes
1
Makes
**USE FOR 40mm FAN with M3 BOLTS**
I wanted to install BLTouch sensor aligning with at least one axis with the extruder, so in front of the fan it goes. It doesn't affect the cooling of hotend that much, as far as I've tested printing PLA at around 210 C'.
It's modified to fit 40mm fan, with just two bolts. I mounted it at the top two bolts, but I think it could work upside down if you really need to, although the z height difference would be problematic.
The height is calibrated for E3D V5 clone hotend, you might need to insert some washers for V6.
I wanted to install BLTouch sensor aligning with at least one axis with the extruder, so in front of the fan it goes. It doesn't affect the cooling of hotend that much, as far as I've tested printing PLA at around 210 C'.
It's modified to fit 40mm fan, with just two bolts. I mounted it at the top two bolts, but I think it could work upside down if you really need to, although the z height difference would be problematic.
The height is calibrated for E3D V5 clone hotend, you might need to insert some washers for V6.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
