Thingiverse
BLTouch BL-ARMOR
di Tinken
5
Download
2
Likes
0
Makes
The BLARMOR was created to not only protect the deploy needle, but more importantly the entire BLTouch itself. Care has been taken into consideration to create a strong cage around the BLTouch without sacrificing the illumination, nor any cooling of the electronics on the reverse side. The base fits directly over the BLTouch and the bottom is angled to help deflect some of the load if a print or obstacle is struct by the BLARMOR.
**Version modifications:
I have made some small tweaks to the original design for a better fit. There is a curved section of the towers which curve around the BLtouch label side. Hole diameters are slightly larger. I have adjusted some lower and upper heights.
I have created a bottom bolted design style. You will need M3 x 40mm for this. The longer bolts increase the part strength, as apposed to having very short screws at the top. Torque placed on the threaded mounting is reduced.
To install, insert M3 bolts from the top (or bottom depending on
**Version modifications:
I have made some small tweaks to the original design for a better fit. There is a curved section of the towers which curve around the BLtouch label side. Hole diameters are slightly larger. I have adjusted some lower and upper heights.
I have created a bottom bolted design style. You will need M3 x 40mm for this. The longer bolts increase the part strength, as apposed to having very short screws at the top. Torque placed on the threaded mounting is reduced.
To install, insert M3 bolts from the top (or bottom depending on
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!