BLTouch Mount for PrintRite DIY 3D Printer

This is a simple mount for a BLTouch Bed Level Sensor for a PrintRite DIY 3D Printer. It mounts on the right side of the extruder carriage using the heatsink and the BLtouch hangs down below it.

Print it with the small tabs on the print bed and the large mounting tab with three holes pointing straight up.

Shape down the two small tabs with a file or sandpaper so that they are a tight press fit into the fins of the heatsink, then secure with a small sheet metal screw that bites in between the heatsink fins.

This does reduce the print area by about 8-10mm to the right, so be aware of that.

This sensor, plus a PEI sheet on my heated bed have been the best of many upgrades I've made to my PrintRite. The BLTouch completely eliminates fiddling with the crappy Z-Axis endstop to set the nozzle height before every print. I've gone from about a 40% first layer failure rate to almost 0% now.

I found a good source for multi-conductor, thin, reliably flexible wire to use for