Thingiverse
BLV MGN Cube Cable Manager
door jsaintrocc
14
Downloads
6
Likes
0
Makes
This is a cable management system for the MGN BLV Cube that will prevent the hotend cables from flopping around and keep the Bowden tube secured but not overly constrained.
You'll need the standard 4 in zip ties to secure the cable guides and you'll also need 1 9mm wide/24 in or longer zip tie to act as the spine. See the BoM below.
.
# BoM
* 1 x [Utilitech 15-Pack 24-in Nylon Zip Cable Ties](https://www.lowes.com/pd/Utilitech-15-Pack-24-in-Cable-Ties/50005756) *Must be ~9mm wide and at least 600mm long*
* [1/2" Flex Tubing](https://www.homedepot.com/p/Gardner-Bender-3-8-in-and-1-2-in-Flex-Tubing-7-ft-and-10-ft-Combo-Pack-FLX-538C10/205588197#product-overview)
* 10 x 4in Cable Ties
* 1 x M3 Square Nut
* 1 x M3 6mm Bolt
# Assembly Guide
[Link to the full assembly guide](https://github.com/jsaintrocc/myblvmgncube/blob/master/manual/guide/17-extruder-hotend-cable-manager.md)
You'll need the standard 4 in zip ties to secure the cable guides and you'll also need 1 9mm wide/24 in or longer zip tie to act as the spine. See the BoM below.
.
# BoM
* 1 x [Utilitech 15-Pack 24-in Nylon Zip Cable Ties](https://www.lowes.com/pd/Utilitech-15-Pack-24-in-Cable-Ties/50005756) *Must be ~9mm wide and at least 600mm long*
* [1/2" Flex Tubing](https://www.homedepot.com/p/Gardner-Bender-3-8-in-and-1-2-in-Flex-Tubing-7-ft-and-10-ft-Combo-Pack-FLX-538C10/205588197#product-overview)
* 10 x 4in Cable Ties
* 1 x M3 Square Nut
* 1 x M3 6mm Bolt
# Assembly Guide
[Link to the full assembly guide](https://github.com/jsaintrocc/myblvmgncube/blob/master/manual/guide/17-extruder-hotend-cable-manager.md)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
