BLV MGN Cube Hemera Mount

This is my take on a mount for the excellent BLV MGN Cube. Its designed to drop right in with the existing MGN rail mounts that Ben Levi designed. There is a slight offset to the print head which didn't exist on the original design, but it's not drastic and the printer still covers the full area of a 330x330 bed. The only modification from the original is to reverse the top two M3 bolts so they enter from the rear and bolt into the inset nuts on the plate.

The design is supposed to integrate with the cable chain listed in the source, it was a design I used on my original ender 3 and was a good chain. It's still work in progress but does work well, just feed the wires through the rounded hole (large enough diameter for stepper/heater/BL Touch/Fan cables) then cable tie it down to stop any movement.

The "Chain Mount V2" and "Chain Mount Clip V2" is the other end of the chain I designed to attach it to the printer frame. This is very much work in progress as I refine the mount. You'