Thingiverse
Board for development
von Mecky_1963
629
Downloads
357
Likes
0
Makes
I constructed this board to hold the above mentioned controller for development purposes.
The part was printed with PLA with a layer of 0.3 mm. Any other filament works too.
No rocket science.
Step file included. F360-file on request. The STL comes without the name tag.
Edit 2021/12/28:
Updated mounting pins for Raspberry Pi 4.
The part was printed with PLA with a layer of 0.3 mm. Any other filament works too.
No rocket science.
Step file included. F360-file on request. The STL comes without the name tag.
Edit 2021/12/28:
Updated mounting pins for Raspberry Pi 4.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
