Thingiverse
Board_storage
door Tom1183
58
Downloads
49
Likes
0
Makes
I designed this board storage for my 3mm and 5mm wood boards i usually use for my sculpfun S9 laser.
The boards messurements on the pictures are 500x300 mm.
The arms on the outside are very strong desingned and they easily will handle the weight of the boards even if you print them with less than 40% infill i realised.
The mounting plates on the inside of my wardrobe are very helpfull to distribute posible tensions on a larger area.
To mount the storage i used simple M8 bolts with washers and nuts.
The boards messurements on the pictures are 500x300 mm.
The arms on the outside are very strong desingned and they easily will handle the weight of the boards even if you print them with less than 40% infill i realised.
The mounting plates on the inside of my wardrobe are very helpfull to distribute posible tensions on a larger area.
To mount the storage i used simple M8 bolts with washers and nuts.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!