Slicer Discord
Bolt68 – 3D-Druckmodell von Thingiverse Thingiverse

Bolt68

von Mr_mlk
79 Downloads
64 Likes
0 Makes
Zum Modell
Holds crossbow bolts so they can be fired from a Umarex T4E HDS 68 (a breech loading paintball shotgun). They can hold both 2 and 3 vane bolt styles.


*NOTE*: This is work in progress.

The shotgun is not very accurate to start with, these do not help with a roughly 20cm group at 5m. They go into the archery mat 4.5cm.

**Bolts**
_Green Ones_
Cheap ones from AliExpress, sizes according to the manufacture:
Length: 7.1cm about 2.79inch
Diameter: 0.75cm about 0.295inch

_Red One_
Hunting Bolt for the Steambow AR-6.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

Mr_mlk veröffentlicht auch auf

5 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen