MakerWorld
Hueforge & Lithophane
Model downloaden
BOOKMARK KITTEN
32
Downloads
74
Likes
17
Makes
Project: BOOKMARK KITTEN Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 56.25x150mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.1mmFilaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Gray Transmission Distance: 2 PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 3 unique filamentsSwap Instructions: Start with Black At layer #8 (0.72mm) swap to Gray At layer #15 (1.28mm) swap to Jade White for the rest.
FYTY112 publiceert ook op
64 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
