Bookmark tattoo

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. Can be printed with manual filament change only (setting filament change or pause in the slicer). No automated material management system is required, but it is better ;). There are beds in the print profile: "Clean" - bookmark without a hole. "With hole" - bookmark has a negative part inserted. Model size size is 50x150mm. Or you can modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 1.84mm and the Actual Depth is 1.84mm. Filaments used/color setting: PLA Anycubic Black Transmission Distance: 0.3 PLA Sunlu Meta Grey Transmission Distance: 3.5 PLA Elegoo Basic White Transmission Distance: 7 This print uses 3 unique filaments Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Grey At layer #13 (1.12mm) swap to White for the rest.