Boost controller holder (Mac valve)

Both Allen bolt and standard bolt versions are included. I recommend using a higher infill to prevent the bolts from crushing the print when tightening. You’ll need to pause the print at layer 67 to insert the nuts (as shown in the attached pictures). If you plan to add a nut on the backside, you can skip this step. It’s best to print using PETG or another heat-resistant filament. Here is the matching bolts and nuts to hold the mac valve.Hillman #6 - 32 x 1-in Phillips/Slotted combination -Drive Machine screws ( 10 -Count )https://www.lowes.com/pd/Hillman-6-32-x-1-in-Phillips-Slotted-Combination-Drive-Machine-Screws-10-Count/3035864