Boveda Humidipack holder (split version)

I really liked the simple and effective design of the Boveda-pack holder by sforion, but I didn't like the fact that you have to pint it standing up, which most likely would have resulted in a not so great finish of the front.

So I split it up into two separate parts which can both be printed laying down on the printbed. The finished parts can then easily be glued together.

While I was already at it, I changed the design of the front a bit to make it appear more modern. But that's just my taste of course.

Please be aware that the parts are a few milimeters wider than the original to compensate for the inner wall I had to add.