Bow Stabilizer

I loved going to the archery range and joining the local league. I did pretty well considering I was using a hunting bow against their target bows. After trying out a couple stabilizer bars I started to notice a difference it made in keeping the bow true thru ought the shot. But I wasn't ready to spend a couple hundy on a long stabilizer for target shooting, and then a shorter one for hunting. So I set off to design one. I know this is like a couple on here, but I wanted a stream lined sexy look, simple, easy to print. At 100% infill the printed parts weigh around 42g with no supports needed.

Parts needed -

3 x Arrow shafts (any length you desire)
2 x 5/16"x24 Bolts (I will return with lengths soon)
1 x 5/16"x24 Nut
1 x 5/16" Flat washer
5/8" flat washers as weights (I'm using 4 that's about 4.6oz)

Print parts -

2 x End pieces
2 x Bolt covers
1 x Washer Spacer (scale the height just shy of your total washer thickness)
1 x Brace (or more if you like)

Assembly -