Bracelet Stand

A six part bracelet stand consisting of a base, two walls, and the three rods that lay across the walls. Great for displaying bracelets, necklaces wrapped around the poles, or charging natural beaded bracelets. The base can also be used as a storage try for other jewelry or anything else you'd like to keep on it. At least one rod must be on the stand to hold it together. Sizing up or down is not recommended, as pieces may not fit together properly and the stand may lose stability. I recommend a minimum of 2 walls and 5% infill for all pieces, but personally do 2-3 walls and 15% infill for strength and support. For a smoother look, print the base at .12 layer height. The rods and walls can be printed higher, my preference it .2 layer height. Heavier or long jewelry might not be fitting for this stand, but please use your own discretion. If you like my work please consider a tip! https://buymeacoffee.com/vogel3dcrar Membership