Thingiverse
Bracket for Z Axis zero return
von Bluefalcon888
3
Downloads
3
Likes
0
Makes
This red bracket shown in the photo enables one to fine tune the Z axis height on the Mendelmax 3 D printer
Install a capscrew 3mm with a nut locked onto the cap head
Use a small hex wrench to micro adjust Z Axis home height
I did not drill or tap the center hole as the 3 mm cap screw screwed in nice and snug into the printed hole......so no need for a lock nut!
Install a capscrew 3mm with a nut locked onto the cap head
Use a small hex wrench to micro adjust Z Axis home height
I did not drill or tap the center hole as the 3 mm cap screw screwed in nice and snug into the printed hole......so no need for a lock nut!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
