Thingiverse
BRANDED | Rubber Stamp Logo
by baschz
48
Downloads
56
Likes
1
Makes
To further decorate envelopes I send out for my web shop, I designed this rubber stamp with my logo.
I know there's not much use for you to have my logo, which I won't include, but maybe someone could use the handle or just the idea. I'm especially loving how the fingerprinty lines came out! That's done using a concentric infill on the initial layer in Cura and also the reason why some of the lines are not that straight in the print. I printed it oriented the other way you would normally do to avoid overhangs, so I the to be stamped part was touching the build plate. This is to ensure a good printing stamp. Orienting it the other way (stamp design up) will result in an inferior stamp quality. And since the lines that didn't print so well aren't touching the material you're stamping on it doesn't really matter.
The handle fits a 30x30mm stamp. To a certain extend you can scale and stretch it to fit your needs.
I know there's not much use for you to have my logo, which I won't include, but maybe someone could use the handle or just the idea. I'm especially loving how the fingerprinty lines came out! That's done using a concentric infill on the initial layer in Cura and also the reason why some of the lines are not that straight in the print. I printed it oriented the other way you would normally do to avoid overhangs, so I the to be stamped part was touching the build plate. This is to ensure a good printing stamp. Orienting it the other way (stamp design up) will result in an inferior stamp quality. And since the lines that didn't print so well aren't touching the material you're stamping on it doesn't really matter.
The handle fits a 30x30mm stamp. To a certain extend you can scale and stretch it to fit your needs.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
