Thingiverse
Brazier
por Petal3D
4
Descargas
9
Likes
0
Makes
This brazier will warm up your diorama! Provide warmth and light to your characters in your tabletop scene. Make a prop to for your summer solstice celebrations.
The default scale is about 1-in-10. Scale as required. Print in the default orientation using PLA, preferably with 100% infill for smaller sizes. Add supports to the brazier. Supports are not required for pole sections and the base.
Clean up, paint and decorate as desired.
Add some flashing red, orange and yellow LEDs for lighting. Run wires through the central hole, add a battery and add a current-limiting resistor.
The default scale is about 1-in-10. Scale as required. Print in the default orientation using PLA, preferably with 100% infill for smaller sizes. Add supports to the brazier. Supports are not required for pole sections and the base.
Clean up, paint and decorate as desired.
Add some flashing red, orange and yellow LEDs for lighting. Run wires through the central hole, add a battery and add a current-limiting resistor.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
