Thingiverse
Bread Spatula
by Lucassg
57
Downloads
59
Likes
0
Makes
As a bread baking enthusiast i was in need of a bread spatula to work my dough. Didn't found any model, so i made this one. It's great for working the dough in any surface, even inside a bowl (circular model). I use it quite hard and it's still holding up!
Normal washing after use.
Looking foward to improve it, so any suggestions about size, grip or anything are more than welcome!
It works perfectly in PLA but i guess PETg would be awesome too!
I use the first layer in 0.05 to bring more elasticity, but 0.1 works great also. Also i suppose increasing infill would make ir a little bit heavier and more comfortable in the hand.
Another suggestion to drasticaly decrease printing time, use variable layer heights, just set 0.1 on the tip of the "blade" and the rest at 0.2 or even 0.25 works perfectly (i achieved 3 hours print!
If Baking some bread, be sure to check out my Flour Sieve (https://www.thingiverse.com/thing:4358309)!!!
Normal washing after use.
Looking foward to improve it, so any suggestions about size, grip or anything are more than welcome!
It works perfectly in PLA but i guess PETg would be awesome too!
I use the first layer in 0.05 to bring more elasticity, but 0.1 works great also. Also i suppose increasing infill would make ir a little bit heavier and more comfortable in the hand.
Another suggestion to drasticaly decrease printing time, use variable layer heights, just set 0.1 on the tip of the "blade" and the rest at 0.2 or even 0.25 works perfectly (i achieved 3 hours print!
If Baking some bread, be sure to check out my Flour Sieve (https://www.thingiverse.com/thing:4358309)!!!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
