Thingiverse
Breadboard Case
par Dorian_the_grey
76
Téléchargements
53
Likes
0
Makes
A simple case to hold the GL-12-F K&H Breadboard commonly used in many university courses, like UNSW and for other projects.
The case has a small compartment on the top section with slide lid lid draw to keep individual components and wires organized. This allows for components in use to be kept in the open lid of the top section, or assembled circuits to be transported with adequate clearance once box is closed.
Breadboard Dimensions:
Fits the GL-12-F K&H Breadboard-840 Tie Points
No support material is used, so slide channel, slide lid and top/bottom edge lips need a little bit of filing to ensure a smooth firm fit.
A piece of wire was used as a hinge. The hinge holes are 3mm diameter, so an M3 bolt should also work well.
Easily adapted and improved to your specific needs.
The case has a small compartment on the top section with slide lid lid draw to keep individual components and wires organized. This allows for components in use to be kept in the open lid of the top section, or assembled circuits to be transported with adequate clearance once box is closed.
Breadboard Dimensions:
Fits the GL-12-F K&H Breadboard-840 Tie Points
No support material is used, so slide channel, slide lid and top/bottom edge lips need a little bit of filing to ensure a smooth firm fit.
A piece of wire was used as a hinge. The hinge holes are 3mm diameter, so an M3 bolt should also work well.
Easily adapted and improved to your specific needs.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
