Breech Plug for Nerf Mega Bigshock

After ripping out the primary air restriction device, I was left with an unsealed hole in the back of my Mega Bigshock. So I quickly threw together this plug. Figured I should share it. It's a tight fit when printed in ABS, easily sealed up with some glue as you tap it flush into place. I didn't print for any unreal detail levels in my installation example photo because it's a functional part, not a visual part. It's not pretty, but for it's intended use, it's skookum as frig.

Giving you two versions for those who don't want my name on your gun, but just in case you do; there ya go~. Make sure you install it with the hollow part to the OUTSIDE of the gun, and that it is FLUSH, no further, with the breech of the gun.

Thinking about doing some more 3D printed mods specifically for this gun as it's been mostly ignored on the 'verse. Comment any ideas you might have, I'll see what I can whip up!