Brick Dragon

Brick dragon 1:1 scale. My Tiefling minifig was missing her dragon partner, so I designed one! Use care when removing supports! When removing supports, if you use too much force, you will break the legs or tail! If your print tolerances are too tight, try increasing/decreasing the main piece. OR if you already have it printed, try using gentle heat, such as a heatgun (from a few inches away) to warm the plastic, then assemble. Using too much heat will melt your plastic. Remember, this is FDM printing, not injection molding like major brick brands. Pins, joints, hinges, etc. are more fragile than popular brick brands injection molded bricks! Using too much force will break smaller pieces! If you have trouble assembling, use a lighter for 1 or 2 seconds and snap the piece in place. Again, using too much heat/flame will melt plastic.