Brick Mold

Super easy to use brick molder. This can be scaled up or down I scaled it down to 60% just to test it and it worked fine. The tolerances were a little tight, but they managed.With all the snowfall recently my son and I were outside playing using small Tupperware to make bricks. Then it dawned on me……3d print a brick mold.________________________________________________________________________________________________________________Once printed you slide the drawer into the bottom put snow in and pack it with the plunger. Once its full you slide out the bottom and push your brick though. It takes like 15 seconds to make one.__________________________________________________________________________________________________________________This is the only part you may need supports on, and you may not even need them if your bridge settings are up to par.This is the gap at the bottom of the body where the drawer slides in._____________________________________________________________________