Thingiverse
BroadSword
von TPPR
0
Downloads
1
Likes
0
Makes
Broadsword full length 1m. Supports only needed for the Hilt and maybe the Pommel. No part is taller than 20cm for printing on smaller printers.
inside I have made holes for strengthening rods they have a diameter of 5.5mm. The rods i used are 5mm and they work fine.
inside I have made holes for strengthening rods they have a diameter of 5.5mm. The rods i used are 5mm and they work fine.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
