Thingiverse
Brompton pedal extension
por Bokix
16
Descargas
12
Likes
0
Makes
CAUTION: Use at your own risk! I printed mine in Markforged Onyx filled with fiberglass so it's plenty strong, I don't know how normal 3D printed plastics will hold up.
I created this pedal extension for the folding and non folding pedal because the pedals were way too small for my large feet and I couldn't find any good larger folding pedals for the Brompton.
You will need:
4x M4x20 + washer -> for the folding pedal
4x M4x20 or similar + washer -> for the non folding pedal
Keep in mind with this design the reflectors will be blocked. I could make a design with the reflectors but I don't see really a use for those tiny reflectors on the pedals personally.
Print with supports in the standard orientation for maximum strength. PLA is not recommended!
I created this pedal extension for the folding and non folding pedal because the pedals were way too small for my large feet and I couldn't find any good larger folding pedals for the Brompton.
You will need:
4x M4x20 + washer -> for the folding pedal
4x M4x20 or similar + washer -> for the non folding pedal
Keep in mind with this design the reflectors will be blocked. I could make a design with the reflectors but I don't see really a use for those tiny reflectors on the pedals personally.
Print with supports in the standard orientation for maximum strength. PLA is not recommended!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
