Thingiverse
Brushed MicroQuad
door mix08tli
19
Downloads
18
Likes
0
Makes
I bought a Propel Star Wars drone (Tie Fighter) but one of the motors started to fail and the drone wouldn't lift-off anymore. So I order some (about 8) 1020 motors of Banggood (link below) but I wasn't really comfortable with the design, where the motors are below and are exposed to crashes.
I started to search ideas about a drone with 1020 motors, but I only found 8520 models, so I based my design on the "Foldable Brushed Microquad" and made some modifications.
The specifications of the Tie Fighter batteries are 3.7V@850mAh but I think a higher capacity battery is required, because the VideoTX drains a lot of power. I will try with 1200mAh batteries (or change the 200mW VTX :S).
The weight of the printed frame is about 20 grams. The assembled drone, without battery weights around 55 grams.
Two variants of the STL files are included, with or without the flight controller supports I required.
I used the camera mount for the Eachine TX02, created by murrayp0473
http://ww
I started to search ideas about a drone with 1020 motors, but I only found 8520 models, so I based my design on the "Foldable Brushed Microquad" and made some modifications.
The specifications of the Tie Fighter batteries are 3.7V@850mAh but I think a higher capacity battery is required, because the VideoTX drains a lot of power. I will try with 1200mAh batteries (or change the 200mW VTX :S).
The weight of the printed frame is about 20 grams. The assembled drone, without battery weights around 55 grams.
Two variants of the STL files are included, with or without the flight controller supports I required.
I used the camera mount for the Eachine TX02, created by murrayp0473
http://ww
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
