Brushless R/C Racing Hovercraft

This is an r/c hovercraft that I designed to be relatively easy to print and assemble, as well as needing no glue for assembly. It only requires a few small screws and pieces of hardware available at any good hardware store, and of course the electronics will also be needed. The design is modular to allow the repair of only certain parts of the craft should damage occur. Some basic tools will also be needed for assembly (any self respecting 3d printing guru should have the tools necessary).

The size of the upper hull (largest part) is small enough to fit on a 300mm build plate, so larger printers should have no problem printing. If you have a smaller printer you may have to cut and print in sections. Everything should be printed in the orientations shown in the photos, .3mm layer height for all works well. Use supports on all but the lower hull, skirt ring and skirt clips.

As you can see from the photos I have flown it quite a bit to test out it's capabilities and strength. I've