Thingiverse
Bubbelicious
von nauseum
47
Downloads
47
Likes
1
Makes
One of the bangles I was working on but vcancelled.. its printable and should look ok, but its is not complete as yet IMO Created using the circle packing script in Grasshopper.
My UP PLus 2 prints undersides terribly, im guessing this would just be a mess on the UP, so mission aborted..
My UP PLus 2 prints undersides terribly, im guessing this would just be a mess on the UP, so mission aborted..
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!