Thingiverse
Bubble Blower
door mrgrotey
1.8k
Downloads
1.4k
Likes
1
Makes
My 5 year old son has special needs and finds blowing a little tricky and therefore using the regular bubble ring is a little difficult.
I found this design online and decided to model it myself.
Works a treat!
The straw is an old straw from one of his plastic drinking bottles and its diameter is Ø7.1mm.
I found that regular bubble mixture is a little thin and not that effective so pouring some into a smal dish (to dip this into) and then adding a tiny bit of Fairy washing up liquid thickens it slightly giving WAY better results.
The only support needed is the underside of the tube at the top and I used concentric support type so it created a matching ring all the way to the underside of the model.
I found this design online and decided to model it myself.
Works a treat!
The straw is an old straw from one of his plastic drinking bottles and its diameter is Ø7.1mm.
I found that regular bubble mixture is a little thin and not that effective so pouring some into a smal dish (to dip this into) and then adding a tiny bit of Fairy washing up liquid thickens it slightly giving WAY better results.
The only support needed is the underside of the tube at the top and I used concentric support type so it created a matching ring all the way to the underside of the model.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
