Thingiverse
Bubble Pools (Remix)
von JenniferG
2.5k
Downloads
1.2k
Likes
9
Makes
Did a plane cut to remove the bubble pools (thank you LIfeburn) from base for use with other terrain such as wargaming mats, rigid insulation / neoprene mat cavern tiles, etc.
The cavern tile in photo was created with DM Scotty's Tilescapes #14 technique (on youtube -- can search for it).
Other scatter terrain is Hirst Arts Water Cavern Mold #82.
There is a small hole under one of the pillars / bubble pools on one of them, after I plane cut it with Mesh Mixer. I printed with supports, no problems.
Base Coat: Espresso Brown.
Sponge / Stipple Brush Coat (Light): Burnt Sienna
Spong / Stipple Brush Coat (Heavier): Cocoa (some dry brushing on 2nd pass)
Dry Brush with very dry brush: Cocoa mixed with Snow White.
(All Americana Paints mentioned above except for Espresso -- that's Home Depot).
The cavern tile in photo was created with DM Scotty's Tilescapes #14 technique (on youtube -- can search for it).
Other scatter terrain is Hirst Arts Water Cavern Mold #82.
There is a small hole under one of the pillars / bubble pools on one of them, after I plane cut it with Mesh Mixer. I printed with supports, no problems.
Base Coat: Espresso Brown.
Sponge / Stipple Brush Coat (Light): Burnt Sienna
Spong / Stipple Brush Coat (Heavier): Cocoa (some dry brushing on 2nd pass)
Dry Brush with very dry brush: Cocoa mixed with Snow White.
(All Americana Paints mentioned above except for Espresso -- that's Home Depot).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
