Slicer Discord
Bullet puller – 3D-Druckmodell von Thingiverse Thingiverse
Bullet puller – Bild 1 Bullet puller – Bild 2 Bullet puller – Bild 3 Bullet puller – Bild 4 Bullet puller – Bild 5 Bullet puller – Bild 6
Tools

Bullet puller

von LionFox · Tools
712 Downloads
444 Likes
5 Makes
Zum Modell
DISCLAIMER: reloading cartridges is a dangerous endeavour.
All reloading and firing of reloaded ammunition is done at your own risk.

Do not attempt to reload until you have read and understood at least one printed reloading manual.
Always wear safety glasses when reloading.
Do not smoke while reloading.
Keep primers and powder away from heat and open flames.
Keep primers and powder where they cannot be accessed by children.
Work up your loads following the standard procedures described in printed load manuals.

To repeat, all reloading and firing of reloaded ammunition is done at your own risk, the author of the "Thing" (Bullet_puller_head.stl and insert9mm.small.stl, insert.357magnum.small.stl, insert10mm.small.stl, insert.45ACP.small.stl , insert9mm.stl, insert.357magnum.stl, insert10mml.stl, insert.45ACP.stl and all contents of the webpage "http://www.thingiverse.com/thing:1502793") assume no liability and no responsibility for death, injuries, or damage due to the
Kategorie
Tools
Quelle
Thingiverse
Veröffentlicht
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen